• Welcome to New Zealand Fighting Game Forum.

News:

Discipline. Justice. Commitment.

Main Menu

JLF super glue does not mix good

Started by redtie, January 31, 2011, 11:47:24 PM

Previous topic - Next topic

redtie

Pretty sure I fucked up my wire harness on my SE stick. Won't respond to any direction. And I think its because I tried to super glue the connection, glue must have run down the holes for the pins and insulated it or something

Solutions? New PCB? New Harness? New 5 Pin connector?

[NIUE] BIRRY WONG

If you cant actually get it off now (given that its super glued) My guess would be new 5 pin connector/harness.

How did you glue it? Did you just shove some glue on the harness and plug it in? Or did you just put glue around the outside of the holes? Unless you used a fair bit of glue i wouldnt have thought that it would insulate the pins like that. Meh. Not sure. Thats my guess, but this is more a Ben/Alan question.
<Smoof>
He's the hero NZism deserves.
But not the one it needs right now.
So we'll hunt him.
Because he can take it.
Because he's not our Hero.
He's a Niuean Guardian.
A watchful poster.
BIRRY WONG.

stereomonkey

You could always solder new wires directly to the pcb on the JLF and see if that works.

Next time use a hot glue gun if your wanting to glue something.
"I got that peanut butter chocolate flavour"

redtie

#3
I used that runny/water like superglue, so I think it did ran those holes and blocked the connections. I'm thinking about soldering onto the pcb directly if coincascade doesn't have any harness's for sale. Yes, I think hot glue would be the better glue next time haha